Skip to main content
LinkedIn
Copied!

Table of Contents

No data flow service nodes are available

Version:

Only available versions of this content are shown in the dropdown

The following exception occurs when you start processing a data flow run: No data flow service nodes available.

Cause

The data flow service is not configured. To configure a data flow service, you must add at least one decision data node on the Data Flow tab of the Services landing page.

Solution

  1. In the header of Dev Studio, click Configure Decisioning Infrastructure Services Data flow .

  2. Click Add node.

  3. Select a node to become a decision data node.

  4. Click Submit.

    The status of the new node is set to JOINING.
  5. Click Refresh to ensure that the status of the decision data node changes to NORMAL.

    Data Flow tab on the Services landing page
    The list contains a single node. The status of the node is
                                        normal.
Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us