Table of Contents

Automatically rerunning failed scenario tests


Only available versions of this content are shown in the dropdown

You can automatically rerun scenario test cases after they fail. Test cases can sometimes fail if there are temporary stability issues on your environment, or if there are first-time First Use Assembly (FUA) issues that could cause the application UI to be rendered slowly.

To automatically rerun scenario tests that fail, do the following steps:

  1. In the header of Dev Studio, click Configure Application Quality Settings .

  2. On the Application: Quality Settings page, in the Scenario test case execution section, select the Re-run tests automatically on failure check box.

  3. In the Number of runs list, select the maximum number of times to rerun failed scenario test cases.

  4. Click Save.

The Application: Scenario testing landing page indicates whether a scenario test has been rerun.
Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.