Skip to main content
LinkedIn
Copied!

Table of Contents

Updating implementation application references

Version:

Only available versions of this content are shown in the dropdown

Follow these steps to update either the Pega-provided implementation application Pega Customer Decision Hub, or your implementation application built on the Pega Customer Decision Hub foundation.

  1. If your rulesets are using Ruleset Validation, ensure that the highest version of rulesets listed in your implementation application has a dependency on the ruleset PegaMKT-Install:08-04-02. If your rulesets are using Application Validation, this step is not required.

  2. Review the application rulesets and verify that they reference the ruleset version that contains all of your existing artifacts and rules.

  3. Ensure the implementation application is built on the application PegaMarketing_FW:8.

  4. On the Cases & data tab, add a reference to the new subscription microsite if it does not already exist.

    microsite configuration

  5. Delete or withdraw any versions of the following data flows that are in your implementation ruleset:

    • DF_ProcessResponse
    • DF_VolumeConstraint
    • DF_Prospect_VolumeConstraint
    • DF_DirectDB
  6. Update the referenced application for the access group PegaNBAM:Agents.

    1. In Dev Studio, click Configure Application Structure Access Groups and Users .

    2. Find and open the access group PegaNBAM:Agents.

    3. In the Application section of the Definition tab, verify that the application in the Name field is your implementation application.

    4. If needed, update the application version in the Version field.

    5. On the Advanced tab, in the Design time configuration section, verify that the default destination ruleset references the Artifact ruleset and version that contains your artifacts.

  7. Review the other access groups for your application. For each access group:

    1. In the Application section of the Definition tab, verify that the application in the Name field is your implementation application.

    2. If needed, update the application version in the Version field.

    3. On the Advanced tab, in the Design time configuration section, verify that the default destination ruleset references the Artifact ruleset and version that contains your artifacts.

      The standard access groups for Pega Customer Decision Hub are:
      • your application:SOAPUsers
      • your application:FieldMarketers
      • your application:FieldMarketingManagers
      • your application:CDHAdmins
      • your application:CDHAnalysts
      • your application:CDHManagers
Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us