Table of Contents

Running simulation tests


Only available versions of this content are shown in the dropdown

From Pega Customer Decision Hub, you can start a simulation test that you already configured. Additionally, you can start a new simulation test or restart an already completed one.

  1. In the Pega Customer Decision Hub portal, click Simulation Testing.

  2. Locate the ID of the simulation test that you want to start and click it.

    You use the filter function to browse through simulations. For more information, see Filtering simulations.
  3. Start the simulation by performing one of the following steps:

    • To start a new simulation, click Start.
    • To start an already completed simulation, click Restart.
    To avoid deleting previous simulation test results, the Clear previous results for simulation test setting must be disabled before restarting.
  4. Optional:

    View the reports that are assigned to the simulations by clicking a report in the Assigned Reports section.

Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.