Skip to main content
LinkedIn
Copied!

Table of Contents

Configuring reports assigned to simulation test outputs

Version:

Only available versions of this content are shown in the dropdown

You can review simulation tests by inspecting a variety of reports that can be assigned to a simulation output. Additionally, you can quickly respond to changes in business requirements or obtain additional data by adding a new report to the simulation.

You can configure reports only for simulations whose status is not Resolved, that is, simulations that you have not yet marked as completed.
  1. In the Pega Customer Decision Hub portal, click Simulation Testing.

  2. Click the ID of the simulation test whose reports you want to access.

  3. In the Assigned reports section, view a report assigned to an output by clicking the report name in the Report column.

  4. Optional:

    To view additional data about the simulation, in the Assigned reports section, click Add report.

  5. Click Submit.

Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us