Skip to main content

Table of Contents

Restarting a Run


Only available versions of this content are shown in the dropdown

If a campaign run stops or fails, you can restart it after you solve the cause of the previous run failure.

New deployments of Pega Customer Decision Hub on Pega Cloud Services are configured to use the Decision Data Store for action state storage. Campaign Run restarts are disabled in this mode. If you want to enable the campaign run restarts feature, see Disabling the Decision Data Store as action state storage on Pega Cloud.
  1. Review and address any errors reported for the previous campaign run.

  2. In the Run schedule section, click Restart for the run which you want to restart.

  3. Optional:

    Enter an explanation note along with the restart request.

The failed run is skipped and a new run is initiated. The new run only sends actions to customers whose actions were not initiated during the failed run, to avoid restarting the campaign from the beginning.
Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us