Skip to main content
LinkedIn
Copied!

Table of Contents

Running simulation tests

Version:

Only available versions of this content are shown in the dropdown

From Pega Customer Decision Hub, you can start a simulation test that you already configured. Additionally, you can start a new simulation test or restart an already completed one.

  1. In the Pega Customer Decision Hub portal, click Simulation Testing.

  2. Locate the ID of the simulation test that you want to start and click it.

    Use the filter function to browse through simulations. For more information, see Filtering simulations.
  3. Start the simulation by performing one of the following steps:

    • To start a new simulation, click Start.
    • To start an already completed simulation, click Actions Restart simulation .
    Restarting a simulation always clears the previous results for the simulation test.
  4. After the simulation has finished running, review the results by clicking Review reports.

  5. Optional:

    If required, you can edit and re-run the simulation after it has finished running, by clicking Actions Edit simulation .

    Editing the simulation settings removes data about the previous simulation run, and changes the simulation status back to In Build.
  6. To mark the simulation as completed, click Wrap up.

    After you wrap up a simulation, it is considered resolved and you can no longer rerun it. However, you can still review any reports created for the simulation.
    On Pega Cloud, you can configure an automatic archiving job for simulation-related case data. For more information, see Creating an archival policy.
Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us