Skip to main content
LinkedIn
Copied!

Table of Contents

Running Value Finder simulations

Version:

Only available versions of this content are shown in the dropdown

Run a Value Finder simulation on an audience to discover which stages of your next-best-action strategy leave customers without any actions or with only low propensity actions, and identify groups of customers that are underserved.

This procedure explains how to create and run simulations on the Value Finder landing page, on which you can perform the following tasks:

  • Running and viewing analysis results for all Value Finder simulations that were created in your system.
  • Creating Value Finder simulations to analyze strategies based on the Next-Best-Action Designer strategy framework.
To analyze a strategy that was created outside Next-Best-Action Designer, or strategy results from a lower-version environment that does not include Value Finder, go to the Simulation Testing landing page and create a Value Finder simulation test. For more information, see Running simulation tests.
  1. Log in to the Pega Customer Decision Hub portal.

  2. In the navigation pane of the Pega Customer Decision Hub portal, click Discovery Value Finder .

  3. To run a saved simulation, from the Simulation list, select a simulation.

    Value Finder runs the simulation automatically.
  4. To create a simulation and then run it, perform the following actions:

    1. Click Create new.

    2. In the Create simulation window, click All issues / All Groups.

    3. From the Issue list, select an issue.

    4. From the Group list, select a group.

    5. Click Apply.

    6. In the Create simulation window, click Audience, and then select the audience for the simulation.

    7. Click Run.

    After you start a simulation, you can navigate away from the Value Finder landing page, and then can come back later when the analysis results are ready. Value Finder runs the simulation and saves it to the Simulation list. The simulation is also available on the Simulation Testing landing page.
  5. To re-run a simulation that you ran before, under the Simulation list, click the Re-run icon.

  6. Optional:

    To toggle the customer distribution view between counts and percentages, in the Show customers as field, select one of the following options:

    • To display results as the numbers of customers in each category and state, select Counts.
    • To display results as percentages of customers in each category and state, select Percentages.
Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us