Skip to main content

Table of Contents

Configuring Pega Robot Manager to use Kerberos authentication for robots


Only available versions of this content are shown in the dropdown

Configure Pega Robot Manager to use Kerberos authentication your robots.

Virtual machine registration is the same for robots that authenticate through Kerberos. However, after you configure work queues and work groups into which robots register, you must perform additional configuration steps for Pega Robot Manager.

  1. Configure service packages to use Kerberos authentication.

  2. Configure the work group into which a robot registers, either on the robot or by using a decision table.

    For more information, see:
  3. Set the order of work group registration.

Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us