Skip to main content
LinkedIn
Copied!

Table of Contents

When I update a solution, why do I receive the error Converted:0. Not Converted:1?

Programs affected: Robot Studio plug-in for Microsoft Visual Studio

When updating an older Robot Studio solution, you might receive a Conversion report that says no files were converted. For example, the report will say:

Converted: 0.

Not Converted: 1.

Here is an example:

Conversion report

Most likely, the solution updated just fine. These messages are a byproduct of Visual Studio and are not relevant to the Pega Robot Studio solution. If, however, a solution does not update correctly, Studio generates an error message and the project is in an unloaded state.

Suggest Edit
Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us