Skip to main content
LinkedIn
Copied!

Table of Contents

Preassembling rules in an application

Version:

Only available versions of this content are shown in the dropdown

The Static Assembler utility enables the preassembly and caching of rules that belong to an application. These actions improve the response time for interactive users after a system startup or when new ruleset versions are imported into the system.

You can run the utility at any time, for example, after you import an application that contains a large number of new rules, after an application upgrade, or after any significant change was made in the application development cycle.

You can run the Static Assembler utility in one of the following modes, depending on your work context.

  • Running Static Assembler in utility mode

    Run the Static Assembler from the /scripts/utils directory within the extracted application installation directory. This is the best practice because the Static Assembler uses information that is in the application installation directory.

  • Running the Static Assembler in stand-alone mode

    Use the stand-alone mode when using the utility at a command prompt and when passing connection details through the setupDatabase.properties file.

Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us