Table of Contents

Article

Troubleshooting: Repeat Grid with Enable Paging does not display all rows

Summary

When a Repeat Grid has Enable Paging checked, and the grid source is a Report Definition that also has Enable Paging checked, the grid sometimes does not display all of the records you expect to see.

Explanation

When the Report Definition form, the User Interactions tab, has Enable Paging checked, the maximum number of records that are retrieved and displayed on the Repeat Grid is restricted. This behavior is irrespective of the Enable Paging option on the Repeat Grid layout element itself.

Suggested Approach

To ensure that the correct number of rows specified in the Report Definition Data Access tab is retrieved, go to the Report Definition User Interactions tab and uncheck the Enable Paging option.

Starting with PRPC 6.2x, you cannot have both options, Enable Paging and Maximum Number Of Rows To Retrieve, enabled at the same time; this is restricted by design.

The following screens illustrate the scenario that causes the problem. The last screen shows the Enable Paging option that you need to uncheck to display all rows specified for the Repeat Grid.

Report Definition, Data Access, General Data Source Settings, Maximum Number Of Rows To Retrieve

Section, Layout, Grid Repeat Layout, General, Paging properties

Report Definition, User Interaction, Paging, Enable Paging checkbox>

Additional Information

When and how to configure paging in reports

Report Definition form, Completing the User Interactions tab

How to add a Grid layout to a section

Using a report definition rule as a data source for a Grid layout

Published February 24, 2014 — Updated October 2, 2015

Have a question? Get answers now.

Visit the Pega Support Community to ask questions, engage in discussions, and help others.