Click the View properties icon in the cell containing the
Tooltip control to display the Properties panel, and select the
Select an edit mode for this control. The edit mode of the control, specified here, takes precedence over section and harness settings.
— the control uses the edit mode of the section or harness in which it appears. If the section is set to Read Only, then the control is Read Only. If the section is set to Auto, then the control uses the edit mode of the harness. For example, a New harness is editable, while a Review harness is read only.
Read Only (expression)
— the property value is presented in read-only mode based on an expression, even when the enclosing layout is in read-write mode.
In the field that appears, select an expression. Click the gear icon to display a form where you can create an expression.
Read Only (when rule)
— the property value is presented in read-only mode always, or based on a when condition, even when the enclosing layout is in read-write mode.
In the field that appears, select a When condition. Click the
to create a new one.
— the control is editable, regardless of the edit mode of the enclosing layout.