You are here: Case management > Modeling advanced processes > Adding a standard shape to a flow > Configuring an End shape

Configuring an End shape

An End shape defines an end of the flow. A flow may contain none, one, or multiple End shapes. When processing reaches this shape, no further processing by this flow occurs. If this flow was called as a subprocess by another flow, processing continues in the calling flow.

  1. Double-click the End shape.

  2. Enter a value in each field of the property panel.

  3. Click OK to close the property panel.

  4. Hover on an existing shape and drag a connector from it to the End shape.

At run time, the case is saved when the End shape is reached, unless the case is temporary. Reaching an End shape does not change the status of a case.

Notes

Related Topics Link IconRelated information