Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Auto complete does not work when the result count is more



The auto complete control does not perform lookup when the result count is more.

Error Messages

Not Applicable

Steps to Reproduce

1. Create a section.
2. Place an auto-complete in the section.
3. Use declare page as source of the auto complete.

Root Cause

A software use or operation error. Autocomplete was not configured as per requirement. The autocomplete configuration was pointing minchars to be displayed but minchars were not entered.
If no minchars is specified, then the autocomplete by default takes 2 as minchars.


Local-change is to modify the minchars to be entered and the maxresults to be displayed.

Published October 5, 2015 - Updated October 8, 2020

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us