Support Article
BIX Command Line Parameters not working as expected
SA-472
Summary
Below command line parameters are not working as expected.
-z <start key> Only extract instances with a pzInsKey equal to or greater than <start key>.
-Z <end key> Only extract instances with a pzInsKey equal to or less than <end key>.
When user gives a range like T-55 to T-57, its picking work cases T-5596, T-5598 and so on…..
Error Messages
NA
Steps to Reproduce
Run BIX thru command line
Root Cause
The root cause of this problem is software use/operation error.
Resolution
The explanation for this behavior is as follows: The pzInskey value is a string. As a result the range of -z to -Z is a string range and not a numerical range.
Published April 1, 2016 - Updated October 8, 2020
Have a question? Get answers now.
Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.