Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Call-Async-Activity Method doesn't show the activity name



When viewing the details of a Call-Async-Activity method step, the activity name is not shown. However, it is saved. This issue only occurs if the parameters tab for the activity being referred to has no parameters on it.

Error Messages

Not applicable.

Steps to Reproduce

  1. Use the Call-Async-Activity Method in an activity.
  2. Specify as the target activity one without parameters.
  3. Observe that when re-opening the Call-Async-Activity method, the specified target activity is no longer shown.

Root Cause

The Pega code handling the presentation of the target activity name was not prepared for the possibility of there being no parameter list.


Either use HFix-36149 or make sure the target activity has at least one parameter definied on its Parameters tab.

Suggest Edit

Published November 6, 2017 - Updated October 8, 2020

Did you find this content helpful? Yes No

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us