Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Data page loads incorrectly on selecting Defer Load content



The requirement is to display the Total Count of the data page result.

On selecting the Defer Load in the top layout, the data page loads incorrectly with no parameter and displays a Max count of 500 even when the grid displays correct results with the parameter.

Error Messages

Not Applicable

  1. Check the Defer Load contents checkbox in the top layout, in the section.
  2. Create a grid with the parameters passed.

Root Cause

An issue in the custom application code or rules.


Here’s the explanation for the reported behavior:

When Defer load content is enabled in the layout, the entire data page is loaded without parameters (Code-Pega-List). The entire data page is loaded at the time. The pxResultCount for the entire result returned from the data page is displayed in the Primary page (Code-Pega-List). However, for the grid, the data page is loaded later with the parameter passed.

Refer to the below screenshot:


Published August 19, 2019 - Updated October 8, 2020

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us