Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Data Transform cannot take parameter when calling from connector



Data Transforms called on a Connector rule of a flow (on Integration layer), do not allow parameters to be passed, though input parameters are defined in the data transform.

Error Messages

Not Applicable

Steps to Reproduce

1. Create a Flow in Integration layer.
2. Crate a data transform with parameters in Integration layer.
3. On one of the connectors of this flow, try to call the data transform mentioned above.

Root Cause

A defect in Pegasystems’ code or rules. When a flow is in Data- or Int- classes (other than work classes), if workclass is set to any work class on the design tab, then the data transform doe not populate its parameters.
The issue is that, when the class name is not passed to the section, pzRuleCallParams, then it takes from work class. But it should take from pyClassName.


Install HFix-23800.

Published October 5, 2015 - Updated October 8, 2020

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us