Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Distorted flow lines after save or check-in of the flow

SA-11111

Summary



The Process Modeler is creating a new modelling in Pega 7 and when connecting shapes to other shapes it all looks right. However, after save and check-in, the lines get distorted.

Error Messages



Not Applicable

Steps to Reproduce



1. Create a new flow in DRAFT mode.
2. Add shapes.
3. Connect shapes with flow lines.
4. Rearrange flow shapes as needed.
5. Rearrange flow line origination and destination points as needed.
6. Save/check-in the flow. Observe that the display is refreshed and the flow lines are distorted.


Root Cause



The root cause of this problem is a defect in Pegasystems’ code/rules.

Resolution



This issue is scheduled to be resolved in Pega 7.1.9. 

Published June 24, 2015 - Updated October 8, 2020

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us