Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Incorrect class and operation name on adding connector to SOAP

SA-58444

Summary



The following issues occur when adding a connector to any SOAP service using the Connect-SOAP method:
  • If the request or response class names in the WSDL is more than 34 characters, Pega by default, cuts about 10 chars from the end of the class name and adds some undefined numbers
  • In the operation names, Pega counts the word 'response' and the word 'request' that are generated with the WSDL as part of the the 34 characters limit and cuts the names from the end such that the final name is of 25 characters only


Error Messages



Not Applicable.


Steps to Reproduce



Add a connector to any SOAP service using the Connect-SOAP method with class or operation names exceeding 34 characters.


Root Cause



The pzSetClassIdentifier section has an identifier field for which maximum allowed character is 25 and this section is a Final rule.


Resolution

Perform the following local-change: 

Limit the class name character to 25.



 

Published August 24, 2018 - Updated October 8, 2020

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us