Support Article
Required Option does not display default control after upgrade
SA-13057
Summary
After the upgrade from PRPC 6.1 SP2 to Pega 7.1.8, all previously-existing Default controls no longer show the "Required" option in the cell properties, and validation no longer functions correctly.
Error Messages
Not Applicable.
Steps to Reproduce
1. On a PRPC 6.1 SP2 system, create a section with cells that are configured to use Default control.
2. Upgrade the system in place to Pega 7.1.8
Root Cause
The root cause of this problem is a defect in Pegasystems’ code/rules. Upon performing the in-place upgrade, the pyAutoHTML property was empty and caused the default option to not be shown.
Resolution
This issue is resolved by HFix-23175, which corrects the issue with the pyAutoHTML property.
Published August 12, 2015 - Updated October 8, 2020
Have a question? Get answers now.
Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.