Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Unable to set additional properties in an AutoComplete control

SA-64800

Summary



Unable to set additional properties in an AutoComplete control.


Error Messages



Not Applicable.


Steps to Reproduce

  1. Configure an AutoComplete control in the section with the source as report definition
  2. Set some additional properties to a different page apart from setting the associated property


Root Cause



The PostValue and Refresh-section in the Actions tab only set the primary property value to the clipboard.


Resolution

Perform the following local-change:

Configure the AutoComplete control with only Refresh-section in the Actions tab so that all the additional properties are set.



 

Published January 9, 2019 - Updated December 2, 2021

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us