Support Article
Values of parameters with & cannot be retrieved
SUMMARY:
Drop down is configured with the source as a report definition. The parameters passed to the report definition contain & in their values. However, the values cannot be retrieved from the report definition.
ERROR MESSAGES:
Not Applicable
STEPS TO REPRODUCE:
1. Create a section with a dropdown field X and an Autocomplete field Y
2. Retrieve some data from the table for dropdown (X) which contains special characters like (&, (,))
3. Pass the dropdown value as a parameter for the Autocomplete field
4. Retrieve values for Autocomplete using the report definition based on the parameter (dropdown X) which must act as a filter condition
ROOT CAUSE:
A defect in Pegasystems’ code or rules.
RESOLUTION:
Apply HFix-56889.
Alternatively,
Perform the following local-change:
- Create a List type datapage
- Use the report definition as the data source for the data page
- Configure an Autocomplete to configure the data page as a List source
Published October 8, 2020
Have a question? Get answers now.
Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.