Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Y axis units are not incremented in sequence



The sequence of Y-axis is not incremented sequentially. It is incremented by 2 from 0-14, but from 14-17 it is incremented by 3.

Expected sequence: 0,2,4,6,8,10,12,14,16,18
Actual Sequence: 0,2,4,6,8,10,12,14,17

Error Messages

Not Applicable

Steps to Reproduce

  1. Create a report definition.
  2. Include a chart control in section.

Root Cause

FusionCharts controls the resizing of the Y-axis based on the values.


Perform the following local-change:
Change the minimum value and maximum value of the Y-axis according to the value range of data.

Published January 2, 2017 - Updated October 8, 2020

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us