Support Article

Calling Show-Harness Activity on-click in action does not work

SA-9803

Summary

You are calling an activity on click of a button using action - Run Activity/ Refresh Section and calling Show-Harness in that activity to display desired Harness but it isn't happening.

Error Messages

None

Steps to Reproduce

In a Button control, execute an Activity, confiure on-click to call Show-Harness.

Root Cause

Reported issue is an expected design behavior.

Resolution

1. On click of Button, launch Harness.

2. In pre-activity, calculate the outcome using input parameter and assign it to a property that can be later used in the launched harness to put condition on layout visibility.

3. Configure your Harness to contain both Success and Failure layouts in a Single harness and then display them, on the basis of outcome from your preactivity, as set in conditions.