Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

No validation in decision tables



There is a column Tier, in which range value entered in such way that
Tier >=30000 and tier<40 which should not be acceptable. But it’s not throwing any validation errors /conflicts and is getting saved successfully.

Error Messages


Steps to Reproduce

1. Open the decision table.

2. Ensure "Evaluate all rows" is checked (since the returned columns contain 2 properties).
3. Under condition: add a column with the range and add the values.


The explanation for this behavior is as follows: 

While creating a decision table, the start and end range needs to be mentioned in the column header only. The particular range needs to be specified as a condition.
User can configure it and then perform an action based on the condition specified. Validation is not done while entering the conditions/range values in the decision table.

Published January 31, 2016 - Updated October 8, 2020

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us