Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Property level message does not display in read-only mode



In Pega 8.2.1, error message does not display on the screen when a property-set-message is configured on a read-only property. The error message displays if the Auto or the Editable mode is selected.

Error Messages

Not Applicable

Steps to Reproduce

  1. Configure a property to use it in the read-only mode.
  2. Use an activity to set the property-set-messages to set the Validation message.

Root Cause

A defect in Pegasystems’ code or  rules.


Perform the following local-change:

Enable the 'Show validation messages in read-only mode' checkbox in the Presentation tab of the property panel.

Published December 2, 2021

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us