Skip to main content

This content has been archived and is no longer being updated. Links may not function; however, this content may be relevant to outdated versions of the product.

Support Article

Refresh Section is not working onchange event for Auto complete



User have an issue with Auto complete control where source is a Data page and has an Onchange event with Pre-activity in which the flags are set which makes the other autocomplete visible.

Error Messages

Not Applicable

Steps to Reproduce

  1. Select a value from first auto complete and configure a refresh section on-change event and an activity too to select some flags.
  2. Configure another autocomplete whose visibility condition will be depending on the above mentioned flags.

Root Cause

An issue in the custom application configuration: it should be ensured that the flags are getting set and then the refresh section should be called.


Perform the following local-change:

First configure the activity and then use post value to set the flag status to the clipboard and then configure a refresh section on-change event of the first autocomplete.

Published March 22, 2018 - Updated October 8, 2020

Was this useful?

0% found this useful

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us