Skip to main content
LinkedIn
Copied!

Table of Contents

Changing the default passivation time-out settings

Version:

Only available versions of this content are shown in the dropdown

Passivation time-out is required for high availability environments and is enabled by default. The length of time that pages, threads, or requestors are idle before they are passivated is defined by default. To change passivation times, add the passivation settings to the dynamic system settings and then enter the preferred values.

Changing passivation time-out values

The following Pega-Engine ruleset prconfig settings define the values for passivation time-outs, in seconds. To increase or decrease the passivation time-out period, change the value.

  • timeout/page – The number of seconds that pages are idle before passivation occurs. The default value is 900 seconds, or 15 minutes.
  • timeout/thread – The number seconds that threads are idle before passivation occurs. The default value is 1800 seconds, or 30 minutes.
  • timeout/browser – The number of seconds that requestors are idle before passivation occurs. The default value is 3,600 seconds, or 60 minutes.

For more information about changing default dynamic system settings, see Learning about default dynamic system settings.

Did you find this content helpful?

Have a question? Get answers now.

Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.

Ready to crush complexity?

Experience the benefits of Pega Community when you log in.

We'd prefer it if you saw us at our best.

Pega Community has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice
Contact us