Conversation
CREDERA
IN
Last activity: 8 Sep 2025 5:57 EDT
Custom DX Component publish shows Success but no rule created / not visible in ruleset or Rule-UI-Components - Pega 24.2
Publishing a custom DX component reports Success to ruleset myRulesetName:01-01-04, but no rule is created.
->No new rule is created in the target ruleset/version.
->Component does not appear in Rule-UI-Components
Coforge
IN
- what is the output of below command ?
- Does operator used for pushing for component checked access group ?
- default access group has access to pushed ruleset ?
Command
npm run list ServerNote: i hope you have already gone through this https://docs.pega.com/bundle/constellation-dx-components/page/constella…
CREDERA
IN
All the components I previously developed on my server are visible, and components from the Pega side are also shown.
--> Previously, we developed in Labs and exported to the application; now we publish directly to the application.
--> I noticed strange behavior: after I changed the OAuth configuration, the component was published to a different (open) ruleset—one that is not the ruleset specified in task.config.json.
Blue Zone Consulting Partners
US
@Akhilesh.MadalaHi Akhilesh,
Something similar happened to me recently, but in my case I had changed my operator's default access group and I forgot to change it back to the application where I needed to publish the DX component... I think if you switch the default access group, that might resolve your problem.
Regards,
-Jose
CREDERA
IN
Thanks for reply Jose
1) By default, we log in via SSO. When I create a branch or component ruleset, I’m unable to publish to it. The command shows success after running, but nothing gets published.
2) I created a separate operator, and with that, I’m able to publish to a branch but not to a ruleset. Again, the command shows success after running, but the component is not actually published.