Support Article
Attachment Section Tabs getting wrapped !
SA-2759
SUMMARY :
The tabs are getting wrapped on the right hand side whenever the workObject is opened.
If the other tab is highlighted, you find them to align horizontally.
The behavior was not observed in PRPC 6.2 .However, the issue started happening in PRPC 6.3 sp1
ERROR MESSAGES :
NA
STEPS TO REPRODUCE :
Launch Portal
Open one of the dynamic Tabs.
On the right hand side of the harness, the attachment section is containing two tabs.
If the tabs are switched, the content for the tabs change and the tabs are getting wrapped if the combined tabs width is more than the displayed content of the active tab.
Stretch tabs do wrap and are designed the same way. Not using stretch tabs was also not solving the issue completely as the space (width) present was very less.
Tabs were not getting wrapped after changing the layout configuration to Fixed.
However,changing to Fixed layout has the following side effect.
After changing the layout configuration to FIXED, on initial load the labels inside the attachment section were coming out of it.
This issue of labels can be fixed with a local-change where the content of the tab was hidden and displayed using javaScript.
The tabs are getting wrapped on the right hand side whenever the workObject is opened.
If the other tab is highlighted, you find them to align horizontally.
The behavior was not observed in PRPC 6.2 .However, the issue started happening in PRPC 6.3 sp1
ERROR MESSAGES :
NA
STEPS TO REPRODUCE :
Launch Portal
Open one of the dynamic Tabs.
On the right hand side of the harness, the attachment section is containing two tabs.
If the tabs are switched, the content for the tabs change and the tabs are getting wrapped if the combined tabs width is more than the displayed content of the active tab.
Root Cause
Stretch tabs do wrap and are designed the same way. Not using stretch tabs was also not solving the issue completely as the space (width) present was very less.
Resolution
Tabs were not getting wrapped after changing the layout configuration to Fixed.
However,changing to Fixed layout has the following side effect.
After changing the layout configuration to FIXED, on initial load the labels inside the attachment section were coming out of it.
This issue of labels can be fixed with a local-change where the content of the tab was hidden and displayed using javaScript.
Published January 31, 2016 - Updated October 8, 2020
Have a question? Get answers now.
Visit the Collaboration Center to ask questions, engage in discussions, share ideas, and help others.